2019 Folds of Honor “Red, White, and Blue Celebration Dinner”
The Albuquerque Scale Modelers club provided a 1/48 scale A-10A Thunderbolt II “Warthog” model for the auction at the Folds of Honor New Mexico’s “Red, White, and Blue Celebration Dinner” fund-raising event held on September 23, 2019, at the Tanoan Country Club in Albuquerque. The Folds of Honor Foundation provides scholarships and other assistance to the spouses and children of soldiers killed or disabled in service to our country. The model was built by Mike Blohm. The Monogram model kit was donated by Brian Peck. The Folds of Honor was very appreciative of our donation and thanked us for again contributing models for their auction. ASM had two F-16 models for their 2018 event.
The model was built as an A-10A of the 78th Fighter Squadron “Flying Tigers” of the 23rd Fighter Group while assigned to the 332nd Air Expeditionary Group at Jacobabad, Pakistan, in March 2002. The scheme was from the Print Scale 48-073 A-10 Thunderbolt II decal sheet. The kit came with decals for a warthog-faced A-10 of the 47th Tactical Fighter Squadron of the 917th Tactical Fighter Group, Air Force Reserve in a Europe 1 paint scheme (two greens and one gray). However, I wanted to build a three grays scheme with the colorful shark mouth used by the 23rd Fighter Group Flying Tigers, as that would be more appealing to any potential bidders on the model.
The kit was built out of the box other than the decals. It is an older kit with raised panel lines, and a lot of fit problems that required sanding. The 1/48 scale kit is pretty huge. I usually build 1/72 scale aircraft, and the A-10 was bigger than a B-17 model in 1/72. It probably had more parts. too. To avoid it being a tail-sitter, I loaded the front of the fuselage below the cockpit with modeling clay holding a lot of fish sinkers–as much as I thought the narrow nose gear would hold. To my dismay, the model sat back on its tail after I had everything put together. The kit does come with a clear plastic “support stand” that I had not wanted to use, but did use in the end. It is way back by the tail and is pretty unnoticeable. I used a whole lot of Master Model Light Ghost Gray (FS36375) and Dark Ghost Gray (FS36320) to paint it. What I really would have liked was a decal or a template for the fake canopy on the underside of the nose that is in Gunship Gray (FS36118). I ended up drawing the outline of that in pencil and then painting it on. I was surprised at how well that came out. Building the ordnance took a long time. I built six CBU-71 canisters (that is the closest thing the pieces match to), four AGM-65 Mavericks and two LAU-88 triple rail launchers, and an ALQ-119 ECM pod. Getting all those attached to the pylons was a major pain.
The base for the model is a large 18 x 20 picture frame. I inserted a thick grey-colored mat under the glass that looked like an aircraft parking ramp, and had a 3 x 4 inch metal plate built with the appropriate wording about the model. That plate and a smaller plate stating “Model by Albuquerque Scale Modelers” were then attached by double-sided tape onto the glass.
The A-10 model sold for $150 in the auction. The winner donated it to the nine-year-old son of one of the scholarship recipients at the dinner. The boy is a special needs child who is “all about airplanes.” So the model is going to a good home. The 2020 Folds of Honor event will be held at a larger venue, and they do want ASM to put on a large model display for that event. So start building for that!